Honey Bear Dolls 16oz UVDTF Transfer (slightly thinner width wise than normal 16oz pls note)

UVDTF Transfer Application Instructions

Materials Needed

• UVDTF transfer print (pre-cured and laminated)

• Substrate (glass, acrylic, metal, plastic, wood, etc.) – clean, smooth, and dust-free

• Squeegee or firm scraper

• Isopropyl alcohol and lint-free cloth

Step 1: Prepare the Surface

1. Clean the substrate thoroughly with isopropyl alcohol.

2. Ensure it is completely dry and free of oils, dust, or fingerprints.

   • A smooth surface ensures maximum adhesion and prevents lifting.

Step 2: Prepare the Transfer

1. Trim the transfer close to the design if needed.

2. Ensure both layers (A film with the print + B adhesive film) remain aligned and intact.

Step 3: Apply the Transfer

1. Peel the A film (print layer) with the B film (adhesive) still attached from its backing.

2. Position the transfer over the substrate carefully.

3. Lay it down starting from one edge to avoid air bubbles.

4. Use a squeegee to firmly press the transfer onto the substrate, working from the center outward.

Step 4: Remove Protective Film

1. Slowly peel off the top protective film at a sharp angle (about 180°).

2. If any part of the design lifts, lay the film back down, press again with the squeegee, and re-peel.

Step 5: Finishing

1. Inspect for bubbles or edges lifting.

   • Small bubbles can usually be pushed out gently with the squeegee.

2. Allow the adhesive to cure fully for 24 hours before washing or handling heavily.

Notes & Tips

• UVDTF transfers adhere best to hard, smooth, non-porous surfaces (cups, mugs, bottles, signs, etc.).

• Not recommended for fabrics or flexible substrates.

• Hand-wash items only; avoid dishwashers for longest durability.

• Store unused transfers in a cool, dry place away from sunlight.

These wraps are NOT to be re sold, we have purchased licensing from designers in order to print and re sell.